Futaba 8UHFS, 8UHPS - Manual (Page 92)

88
+100%
+50%
0%
-50%
-100%
←
Servo Response
→
Revolution IDL1 Curve Example
+100%
+50%
0%
-50%
-100%
←
Servo Response
→
Revolution IDL2 Curve Example
LOW ← throttle stick → HI
1 2 3 4 5
Curve Point
0%
-10%
-17%
-25%
10%
0%
-10%
-17%
-25%
10%
LOW ← throttle stick → HI
1 2 3 4 5
Curve Point
Inputting Revolution Five-Point Curves
To PI-CRV
function
To REVOLU
IDL1 function Data input keys
These keys are used
to move through the
five submenus in the
REVOLU function.
The bottom arrow shows the point
on the five-point curve currently
being set.
Top arrow indicates the current stick
position (2 arrows means it's between
points)
Curve points 1-5
Curve Name
Display
(NORM)
Input 5-point curve values
Move the lower arrow to the
position you want to set with the
CURSOR keys (the curve point is
indicated by the arrow below the
numbers 1-5, and the current
throttle position is above the
numbers). Enter the desired curve
value with the (+)/(-) keys.
• If you're unhappy with what you've
set, you may return to the default
value by pressing the (+) and (-)
keys simultaneously.
Curve Point Value
(Range: 0 - +100%)
Initial curve settings:
POS1 = 0%
POS2 = 25%
POS3 = 50%
POS4 = 75%
POS5 = 100%
The Revolution Normal function is on at startup.
It can be turned ON/OFF with the (+)/(-) keys.
The blinking item on the
setting screen is the
current setting item.
Revolution Idle-Up 1 & Idle-Up 2 Curve Setting
The REVOLU IDL1 &/or IDL2 functions will not operate until the
OFST1 and/or OFST2 functions are activated, which also
activates the IDL1 & IDL2 Pitch & Throttle curve menus.
You can activate idle-up 1 and idle-up 2 independently.
The curve inputting procedure is the same as normal curve
described above.
To REVOLU NORM
or IDL1 function
To REVOLU IDL2 or INVERT function