Futaba 8UHFS, 8UHPS - Manual (Page 35)

31
The parameter function includes a number of submenus that are used to input basic
model data settings. This is best understood by viewing the menu structure on p. 16.
To TRAINR
function
To REVERS
function
"NEXT" indicates that there is
a group of submenus in the
PARA function .
Use the (>)/(<) keys to move to
the other submenus within the
PARA function.
PARA includes five
functions:
• Data reset
• ATL
• Engine starter
• Model type
• Modulation.
The Date Reset function is used to clear out an existing set of model data. This may
be used to input new model settings into a memory used for another model. It resets
all data to initial values.
Resetting the memory
To TRAINR
function
To REVERS
function
Confirmation message "OK?"
MODEL DATA RESET
Press both the (+) and (-) keys
simultaneously. The confirmation
message "OK?" is displayed at the
top left corner of the screen.
When both (+) and (-) are pressed
simultaneously again, the reset
process is begun. After a beep,
beep, beep tone is sounded, a
continuous beeeeep tone
indicates that the reset is
complete.
NOTE: The existing modulation, model type, and trim display method settings are not reset. If the power
switch is turned off while a reset is underway, the data may not be reset.
Data input keys
These keys are used to
move through submenus in
the PARA function.
To protect you against inadvertently resetting a model memory, a double setting (double push) system is
used. If the (-) key is pressed to halt resetting after the confirmation message is displayed, the display
returns to its original screen, and no changes are made.
The ATL trim function enables the trim lever to function only at the throttle stick idle
position and disables trim at high throttle, where it prevents pushrod jamming due to
trim changes made at idle.
To TRAINR function
To REVERS function
Current setting (ON or
OFF displayed). Initial
value: ON.
ATL ON/OFF setting
Select ON or OFF with the (+)
and (-) keys.
Data input keys
These keys are used to move through submenus in the PARA function.