Futaba 8UHFS, 8UHPS - Manual (Page 37)

33
HELI SR-3 Type
If the servo inputs match the figure, use SR-3
Mixing.
Aileron
(Pitch)
Pitch
(Aileron)
Front
Elevator
120
120 120
With Aileron inputs, the aileron and pitch
servos tilt the swashplate left and right;
With Elevator inputs, the three servos tilt the
swashplate fore and aft;
With Pitch inputs, all three servos raise the
swashplate up and down.
HELI SN-3 Type
Use SN-3 Mixing if the servo inputs match
the figure.
Aileron
Pitch
Front
Elevator
120
120
120
With Aileron inputs, the three servos tilt the
swashplate left and right;
With Elevator inputs, the elevator and pitch
servos tilt the swashplate fore and aft;
With Pitch inputs, all three servos raise the
swashplate up and down.
Use the reversing function (REV) as necessary to get the proper aileron, elevator,
and pitch operations.
SETTING METHOD
To TRAINR
function
To REVERS
function
Type display
(ACRO, GLID1FLP, GLID2FLP,
HELISWH1,HELISWH2,
MODEL TYPE CHANGE:
Select Model Type with the (+)/(-)
keys – the type name flashes on
and off. Next, press the (+)/(-)
keys simultaneously. At this point,
an "OK?" confirmation message is
displayed. If you press the (+)/(-)
keys simultaneously again, the
model type change is started. A
continuous beep indicates
completion.
*NOTE: if you change the model
type, you'll lose the contents of the
memory. To halt model type
change after the confirmation
message is displayed, press the
(-) key. This will returns you to the
original screen.
NOTE: If the power switch is
turned off while a TYPE change is
underway, the data may not be
reset.
Data input keys
These keys are used to
move through submenus in
the PARA function.
HELISWH4, HELISR-3, or
HELISN-3)