Futaba 8UHFS, 8UHPS - Manual (Page 40)

36
The Model function includes a number of submenus that are used to manage the
model memory. This may be better understood by viewing the menu structure on p.
20.
To TRIM function
To TRAINR function
"NEXT" indicates that there is
a group of submenus in the
MODEL function .
Call the function in the
MODEL submenu with the
(>)/(<) keys.
Data input keys
These keys are used to move through submenus in the MODEL function.
MODEL functions
• Model Select
• Model Copy
• Model Name
The Model Select function allows you to choose from all of the different sets of model
data stored in the transmitter (eight models can be stored within the transmitter, and
data for eight additional models may be selected from the optional DP-16K
memory module, which is sold separately). The SEL function is used to select the
model memory set to be loaded. If you select a model from the memory module, the
letters “PAC” on the display will flash on and off.
Choosing another model memory to load
To TRIM function
To TRAINR function
Confirmation
message "OK?"
MODEL CHANGE
Select the model with the (+)
and (-) keys. When you have
the right number, press the
(+) and (-) keys
simultaneously. The
confirmation message "OK?"
is displayed.
Data input keys
These keys are used to move through submenus in the MODEL function.
Name of
model to be
loaded is
"MDL-02."
Model no. to be
loaded Model No.
When the (+) and (-) keys are simultaneously pressed again, the new model
memory is selected. At the same time, the model number display changes.
you don't wish to change models, press the (-) key to halt model change after
the confirmation message. The display then returns to its original
The COPY function is used to copy the current model data into another model
memory, which may either be inside the transmitter, or in the optional DP-16K
memory module. This function is handy to use to start a new model that’s similar to
one you have already programmed, and is also handy for copying the current model
data into another model memory as a backup. If the data are stored in the memory
module, you can easily transfer the settings to friend’s transmitter, which will save a
lot of programming time.