Futaba 14MZ - Manual (Page 116)

Throttle mixing
This function corrects slowing of engine
speed caused by swash plate operation at aileron
or elevator operation. The method of applying
clockwise or counterclockwise torque when
pirouetting can also be corrected.
An acceleration function which temporarily
increases the throttle side correction rate relative to
rapid stick operation can also be set.
Setting example
● AIL to THR applies a load to the engine and
corrects sinking of the engine speed when
the throttle stick was operated. Engine
racing can be adjusted independently at
the right aileron and left aileron by Rates A
and B.
● Return to Model Menu
● Touch the [Throttle Mix] button in the Model
Menu to call the setup screen shown below.
Setting method
● When using this function, touch the [INH] button
and display [ON] or [OFF].
● When you want to set the same contents at other
conditions, select the group model (Gr.). When
you want to set the selected condition only, select
the single mode (Sngl).
● The correction rate can be set by curve.
● A switch can be set.
When [NULL] is set, the function is operated by
merely selecting the condition.
When setting an [ON]/[OFF] switch, touch the
[NULL] button and then set the switch and its ON
direction at the <Switch> screen.
When correction is necessary, touch the mixing
corresponding to the mixing that needs correction
to call the curve setup screen, and then correct the
<Acceleration function setting>
● Acceleration can be set for both settings
(High) and (Low) at maximum correction
rate.
● Acceleration rate setting (Rate)
● The return time (Dump.) after operation can
be set.
● The operation point when the correction
rate is increased and decreased can be
set independently. When an operation
point is exceeded, acceleration operation
is performed.
116 <Model Menu (Helicopter Functions)>
slowing.