Futaba 14MZ - Manual (Page 95)

Trim Mix 1/2 [Corresponding model type]: Glider, 2 ailerons or more
These functions call the ailerons, elevators, and
fl aps (camber fl aps, brake fl aps) trim offset rates
preset according to the fl ight state.
The amount of ailerons, elevator, and flaps
(camber fl ap, brake fl ap) trim offset can be set to
a switch.
As an example Trim Mix 1 can be set up for
launching, with speed fl aps and ailerons dropped,
and a slight amount of up elevator. Trim mix
2 can be used for high speed flying, with both
ailerons and speed fl aps refl exed slightly, and a bit
of down elevator.
The trim functions can be activated during
fl ight by setting a switch. To prevent sudden trim
changes when switching fl ight conditions, a delay
can be set to provide a smooth transition between
the two. Trim Mix 2 will have priority over Trim
Mix 1.
●Return to Model Menu
● When a fi ne tuning VR is set on the next page (2/2), the ailerons
and fl aps trim rates can be adjusted.
Touch the corresponding button and adjust the rate with the
adjustment buttons displayed on the screen.
● The ailerons, flaps, and elevators
offset rate can be adjusted.
Touch the corresponding button
and adjust the rate with the
adjustment buttons displayed on
the screen.
● Touch the [Trim Mix 1] button in the Model Menu to
call the setup screen shown below.
(The display screen is an example. The actual screen depends on the
model type. The screen shown below is for 4 ailerons and 4 fl aps.)
(Touch the [1/2] button to switch to page 2.)
● Touch the ACT button and set the function to ACT
(ON).
● When setting a switch, touch the Switch button
to call the <Switch> screen, and then select the
switch and set its ON direction. (Always ON at "NULL"
setting)
(For a description of the switch selection method, see the description at
the back of this manual.)
Example
1. Touch the ACT button and set the trim mix function
to [ON].
*When separating the settings for each condition, touch the
group mode button and set it to [Sngl].
2. Select the ON/OFF switch.
3. Select the [Manual] or [Auto] mode.
In the [Auto] mode, also select an auto SW. This
switch can be linked to a stick, etc.
<Speed>
In: The operation speed at switch ON can be set.
Out: The return speed at switch OFF can be set.
<Fine Tuning>
The offset rate can be varied in the Fine Tuning
numeric range set at screen [1/2] by VR, etc.
selection.
<Condition Delay>
When
fl ight conditions are set, the operation speed
can be set for each condition. Condition delay
operation can be interrupted and each rudder
quickly returned to its original position by selecting a
cut switch.
95 <Model Menu (Airplane/Glider Functions)>