Futaba 14MZ - Manual (Page 69)

●Return to Linkage Menu
● Touch the [Timer] button in the Linkage Menu to
call the setup screen shown below.
Timer Timer setting and lap time display.
The Timer function may be set for any desired time,
i.e. engine run time, specifi ed times for competitions,
etc. Two independent timers are provided for your use.
The timers are stored independently with each model,
meaning that when you switch between model setups,
the timer associated with the new model is brought up
automatically.
The timers may be set to start and stop from the
motion of any switch or stick. You may set the ON and
OFF directions freely. Each timer has a capacity of up
to 59 minutes 59 seconds.
Up timer/down timer selection
1. Touch the mode button and select the type
of timer.
*Each time this button is touched, it toggles between UP and
DOWN.
2. Timer time setting
Touch the Mode minutes or seconds button.
Adjustment buttons appear on the screen.
Use these buttons to set the timer time.
Start/stop switch setting
1. Touch the Start/Stop SW "NULL" button to call
the <Switch> screen, and then select the
switch and its ON direction.
(For a detailed description of the selection
method, see [Switch Setting Method] at the
back of this manual.)
Each timer may be set for count-down or count
up operation with a target time. Also Split Time
may be counted.
If a target time is set and the timer reaches the set
time, a buzzer sound for each count is generated.
Countdown timers sound one short beep during the
last twenty seconds and two short beeps during the
last ten seconds before reaching the target, then a long
tone at the target time, and continue counting with
displaying a minus (-) sign. Count-up timers also beep
the last twenty and ten seconds, beep the target time,
and keep counting upwards until shut down.
Lap time switch selection
1. Touch the Lap SW "NULL" button to call the
Prog. Mix screen, and then select the switch
and its ON direction.
(For a detailed description of the switch
setting method, see [Switch Setting Method]
at the back of this manual.)
Timer operation
● Timer 1 and Timer 2 are started and stopped
by start/stop switch set beforehand.
● To count the lap time, operate the lap time
switch selected beforehand. Each time this
switch is operated, the lap time is stored. To
display the lap time, touch the respective
[List] button.
● To reset a timer, touch the respective [Reset]
button.
To exit the setting, touch the [Timer] button.
●Return to Timer
screen
<Lap time list>
69 <Linkage Menu>