Futaba 14MZ - Manual (Page 14)

•Antenna storage
When you store the transmitter in the carrying
case, detach the antenna and store it in the antenna
compartment in the transmitter.
● Antenna Compartment
Cover
•Angle adjustment of the antenna
You can change the angle of the antenna, as
you like. Use 2.5mm hexagonal wrench to turn
counterclockwise to release the screw on the left
of the antenna holder, and change the angle of the
antenna, as you like, then retighten.
●Screw
LED monitor
The color of the FUTABA logo mark shows the
status of the transmitter.
(LED Display)
• When you turn on the transmitter, FUTABA
logo shows different colors, and then the
color stays constantly pink. The FUTABA
logo blinks green very rapidly while internal
processing is carried out after the power is
turned on. Once the internal processing is
over, the logo turns to pink color.
• The FUTABA logo turns on blue when you
use DSC cable, or when no is selected for
transmit. when the trainer function is set at
student's side.
• The FUTABA logo blinks red slowly when you
attach the RF module that is different from
the setting.
• Under the normal usage (, that is, radio wave
is being emitted), the FUTABA logo turns on
green.
Switch reallocation
You can reallocate the toggle switches on the
shoulders of the transmitter, as you like.
(Default settings)
• SA : 3 positions; Alternate; Short lever
• SB : 3 positions; Alternate; Long lever
• SC : 3 positions; Alternate; Long lever
• SD : 3 positions; Alternate; Short lever
• SE : 3 positions; Alternate; Short lever
• SF : 2 positions; Alternate; Long lever
• SG : 2 positions; Alternate; Short lever
• SH : 2 positions; Momentary; Long lever
*You can choose switch and set the ON-direction in the
setting screen of the mixing functions.
•When you change switches:
●Screw
To relocate switches;
1. Make sure your transmitter is off, and use the
attached 2.5mm hexagonal wrench (inside
stylus) to turn the screw counter-clockwise on
the switch block and detach the block.
14 <Before Use>