Futaba 14MZ - Manual (Page 67)

●Return to Linkage Menu
●Touch the [Swash] button in the Linkage Menu to
call the setup screen shown below.
Swash Swash operation linkage correction function.(helicopter only)
Neutral Point
At your linkages, if the servo horn deviates
from a perpendicular position at neutral, the
linkage compensation functions in this menu
may not compensate effectively. To correct
this use the Hovering Point function. This will,
move the neutral point of the servos to the actual
perpendicular position. However, this adjustment
changes only the datum point of the compensation
functions in this menu, and does not affect the
neutral position of other functions.
Neutral point setting procedure
*Before using the correction function, set the neutral point.
*Adjusting the servo horn so that the neutral point is near the
50% position makes the mixing amount small.
1. Hold the servo horn at a right angle to the
linkage rod, and then touch the [Enter]
button and read the actual neutral position.
*The neutral position is displayed on the screen.
After reading the neutral point, use the
other correction functions to make further
adjustments.
To exit the setting, touch the [Swash] button.
Swash AFR
Swash AFR function reduces/increases/reverses
the rate (travel) of the aileron, elevator and
collective pitch functions, by adjusting or reversing
the motion of all servos involved in that function,
only when using that function. Since H-1 uses one
servo for each function, there is no need for Swash
AFR in H-1.
Swash AFR setting procedure
1. Touch the button of the AFR rate to be
adjusted. Adjustment buttons appear on the
screen.
2. Use these buttons to adjust the AFR rate.
●Initial value: +50%
●Adjustment range: -100%~+100%
To exit the setting, touch the [Swash] button.
●To Swash
Details screen
67 <Linkage Menu>