Futaba 14MZ - Manual (Page 16)

Digital trim
This transmitter is equipped with digital trims.
Each time you press a trim button, the trim position
moves one step. If you continue pressing it, the trim
position starts to move faster. In addition, when
the trim position returns to the center, the tone will
change. You can always monitor trim positions by
graphics on the screen. To change the trim rate,
you must activate this through the function menu,
within the linkage menu. Touch the trim button and
you will access another screen which enables you
to change the trim percentages.
●T6 ●T5
●T1 ●T4
●T3 ●T2
Note: The trim positions you have set will be stored in the
non-volatile memory and will remain there.
Touch Panel/ Rotary Key/ Direct Key
●Direct Key
●Rotary Key
●LCD Display
(Touch Panel)
(S1-S4)
Touch panel, rotary keys and direct keys are used
for entering data.
Touch Panel
Touch the panel with your fi nger or the attached
stylus pen, which is also used as a toolbox, to enter
data.
*Plastic film is attached on the glass of the touch panel.
Please be careful so that you don't scratch the touch panel
with something hard, such as metal and sand sticking on
the surface. And don't push the touch panel too hard and
don't give any physical shock to the surface.Although you
may find some air bubbles under the plastic panel due to
environmental changes such as temperature, it is not a
defect.
Rotary key
In addition to touch panel, you can select items
by rotating the rotary keys to the left or to the right.
Direct key
You can directly call your favorite functions or
menu screens.
(The default setting at the factory)
S1: System menu
S2: Linkage menu
S3: Model menu
S4: Return
[How to change assignment of the direct key]
1. Open the screen you want to call. Then push
S1 and S4 keys simultaneously. (You will see
the direct key setting screen.)
2. Select the direct key.
16 <Before Use>