Futaba 14MZ - Manual (Page 68)

●Return to Linkage Menu
Mixing Rate
This compensation mixing is used to correct the
tendency of the swash-plate for each control near
the hovering point. The following compensation
mixings is possible; PIT to AIL, PIT to ELE, AIL
to PIT, ELE to AIL, and ELE to PIT. It adjusts the
swash-plate to operate correctly for each control
near the hovering point using the corresponding
compensation mixings.
Mixing rate setting procedure
1. Touch the Mixing Rate button you want
to set. Adjustment buttons appear on the
screen.
2. Use these buttons to adjust the mixing rate.
●Initial values:
PIT to AIL, PIT to ELE, AIL to PIT: 100%/100%
ELE to AIL, ELE to PIT: 50%/50%
To end setting, touch the [Swash Details]
button.
Linkage correction setting procedure
1. Adjust the rate with the adjustment buttons.
●Adjustment range: 0%~100%
Note: When using the linkage correction function,
readjust swash AFR for maximum blade angles
because the maximum rudder angle changes.
To end setting, touch the [Swash Details]
button.
Linkage Compensation
This compensation mixing is used to correct the
tendency of the swash-plate for pitch control at low
pitch and high pitch. It adjusts the swash-plate to
move horizontally for collective pitch control using
the corresponding compensations.
Elevator Delay/Speed Compensation
This function is used to cancel the reaction when
the swash-plate moves in the vertical direction
by sudden elevator changes. The delay amount of
elevator can be programmed.
Speed correction setting procedure
1. Use the adjustment buttons to adjust the
delay.
●Initial value: 0
●Adjustment range: 0~100
To end setting, touch the [Swash Details]
button.
●To Swash
AFR screen
68 <Linkage Menu>