Futaba 14MZ - Manual (Page 120)

Governor mixing
This is used to switch the RPM of the helicopters
head. Up to 3 rates can be set for each condition.
*The governor is used by connecting the governor speed
setting channel to CH7 (initial setting).
*When using an independent governor [ON]/[OFF] switch,
connect the AUX([ON]/[OFF]) connector of the governor to
CH8 (initial setting) and set the switch to CH2 (Governor2)
at the Function menu of the Linkage Menu.
● Return to Model Menu
● Touch the [Governor] button of the Model
Menu to call the setup screen shown below.
Setting method
● Touch the [INH] button of the rate to be used and
display [ON].
● When you want to set the same contents at other
functions, select the group mode (Gr.). When you
want to set the selected condition only, select the
single mode (Sngl).
● Three speeds (rates) can be set for each condition.
(Rate 1/Rate 2/Rate 3)
Also, this mixing and the governor side speed
setting must be matched beforehand by the
following method:
● Set so that when the governor side is placed in
the speed setting item state and [2000rpm] of
Set GOV of the screen above is touched, the
governor speed is set to "2000", when the [1500rpm]
button is touched, the governor speed is set to
"1500", and when the [1000rpm] button is touched,
the governor speed is set to "1000".
*When using the Fuel Mixture function, the mixture servo
is controlled from the governor. When transmitting the
mixture curve data from the transmitter to the governor, the
governor AUX (m.trm) connector must be connected to CH8
(initial setting) and governor side setting performed. See the
governor instruction manual.
Note: Always set (Act) and (Trim) to [NULL] for
[Governor] and [Governor 2] of the Function menu.
● When you want to read the speed directly, press
the [%] button and display [rpm].
● The speed can be witched by setting a switch.
Also, when [OFF] is set instead of speed setting,
the governor can be turned [ON]/[OFF] without
setting a separate [ON]/[OFF] switch.
● A speed fi ne tuning VR can be set.
*VR selection, adjustment width, and adjustment direction
can be set.
120 <Model Menu (Helicopter Functions)>