Futaba 14MZ - Manual (Page 92)

ELEVATOR
ELEVATOR 2
V-TAIL
ELEVATOR ELEVATOR 2
AIL EVATOR
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
● Mixing curve setting
(For a description of the curve setting method, see the
description at the back of this manual.)
● Fine tuning VR setting
●Return to Model Menu
Camber FLP to ELE [Corresponding model type]: Airplane/glider, 2 ailerons + 1 flap or
more
This mixing is used to correct changes (elevator
direction) generated when the camber fl aps (speed
fl aps) are used.
● The elevator servos up side/down side rate can be
adjusted. When the mixing direction is reversed
by the linkage, adjustments can be made by
changing the mixing rate polarity.
● A mixing curve can be set.
● Mixing during fl ight can be turned ON/OFF by
setting a switch. (Always ON at NULL setting)
● The mixing rate can be fi ne-tuned by setting a VR.
● Touch the [Camber FLP to ELE] button in
the Model Menu to call the setup screen
shown below.
*The display screen is an example. The actual screen
depends on the model type.
●Curve display mode switching
(Single/Fine tuning/All Cond.)
●Elevator rate adjustment
● Group/single mode switching
(Gr./Sngl)
(For more information, see the description
at the back of this manual.)
● Overall
adjustment
by Rate A
and Rate B
Setting method
● Touch the ACT button and set the function to
ACT(ON).
● When setting a switch, touch the switch button
to call the <Switch> screen, and then select the
switch and set its ON direction. (Always ON at
"NULL" setting)
(For a description of the switch setting method,
see the description at the back of the manual.)
● Touch the elevator servos left and right buttons
and adjust the mixing rate with the adjustment
buttons displayed on the screen.
*When the mixing direction is reversed by the linkage,
adjustments can be made by changing the mixing rate
polarity.
● When setting a VR, touch the Fine tuning "NULL"
button to call the <Switch> screen, and then
select the VR.
The VR operation mode can be selected.
● A mixing curve can be set.
(For a description of the curve setting method, see
the description at the back of this manual.)
●The curve operation mode can be changed.
Single : Displays only the mixing curve
Fine Tuning : Displays the adjustment rate of the
ine tuning VR
All Cond. : Displays the mixing curve of all the
conditions (when conditions are set)
92 <Model Menu (Airplane/Glider Functions)>