Interlogix Simon XT Tabletop User Manual - Manual (Page 19)

Simon XT TableTop Control Panel User Manual 13
Note: The designated door may be opened and closed only once. If you close
the designated door behind you when you exit, you will have to disarm the
system upon reentering. Leave the designated door open while using the quick
exit feature.
Exit delay extension
If enabled by your installer, the exit delay extension feature will recognize when
you arm the system, leave your house and then quickly re-enter your house
(such as you would if you forgot your car keys.) In such a case Simon XT will
restart your exit delay to give you the full exit delay again.
Bypassing sensors
Bypassing a sensor allows you to open the sensor while the system is armed.
For example, if your doors and windows are armed and you want to open your
kitchen window but do not want to disarm the entire system, then you can bypass
the kitchen window sensor and then open the kitchen window without causing an
alarm. Bypassed sensors are automatically unbypassed when the arming level is
changed to a level where the sensor is not active.
Bypassing
To bypass sensors, do the following:
1. Press Bypass and enter the master code.
2. Scroll up/down until you reach the sensor to be bypassed.
3. The display shows, for example, Sn 1 Front Door on the first line.
4. Press Enter to bypass (deactivate) the sensor.
5. When a sensor is bypassed, the panel displays Bypassed on the second line.
Unbypassing
To unbypass sensors, do the following:
1. Press Bypass and enter the master code.
2. Scroll up/down to the sensor to be unbypassed. The sensor must be currently
bypassed.
3. Press Enter to unbypass (reactivate) the sensor.
4. The panel removes the word Bypassed from the second line of the display.