Interlogix Simon XT Tabletop User Manual - Manual (Page 30)

24 Simon XT TableTop Control Panel User Manual
• Communication troubles with the central monitoring station
When your security system detects one of the problems above, six rapid beeps
sound every minute until the trouble condition is corrected. To stop the trouble
beeps, press Status or arm/disarm the system while the trouble condition exists.
Trouble beeps will resume four hours later unless the trouble condition is
corrected.
The following list explains the trouble beep conditions:
AC power failure
This condition (if programmed by installer) occurs if your security system has
been accidentally unplugged or if there has been an AC power outage. Any
status lights go out immediately, and trouble beeps start after five minutes. If you
press any button, the display will light and pressing Status will show the AC
failure. If AC power is not restored within a programmed period of time (5 to 254
minutes) the system will call the central monitoring station. The backup battery, if
fully charged, will last for 18 to 24 hours
—depending on the load applied to the
panel —with no AC power.
System battery failure
This condition occurs if the emergency backup battery has failed. Trouble beeps
will start. Press Status and the display will show
System Low Battery . If your AC
power is not working, your security system will shut down once the battery has
failed. If the condition does not clear after AC power has been restored and 24
hours have passed, call your security system dealer.
Restoration of power
This condition occurs after a complete loss of power (AC and battery). When
power is restored, the panel will return to the arming state with the same zones
bypassed it had prior to losing power.
Sensor failure
This condition occurs if a sensor is not communicating with the panel. Trouble
beeps will start and the Status button will light. Press Status and the display will
show what sensors have failed. Perform sensor tests. You may need to call your
security system dealer if the problem continues.
Sensor low battery
This condition occurs if a system sensor has a low battery. The sensor may still
be communicating with the panel. Trouble beeps will start and the Status button
will light. Press Status and the display will show what sensors have a low battery.