Interlogix Simon XT Tabletop User Manual - Manual (Page 40)

34 Simon XT TableTop Control Panel User Manual
To change the duress code, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Access codes, then press Enter.
3. Scroll up/down to Duress code, then press Enter.
4. The current value of the code now flashes. Enter a new code (use correct
length), then press Enter.
5. Press Status repeatedly to exit.
Initially, the duress code is blank. You can delete the duress code by pressing
Disarm while the code is being changed.
Security
The Security menu contains the download enable option. This option determines
whether your dealer can access the system remotely.
To program the download enable option, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Security, then press Enter.
3. Scroll up/down to Download enable, then press Enter.
4. The current value of this option now flashes. Scroll up/down to toggle this
option on/off, then press Enter.
5. Press Status repeatedly to exit.
Phone numbers
Phone #4 is the only system phone number that you can change. Therefore, it is
often used for voice reporting of alarms to your phone, if it was programmed for
this purpose by the installer.
To change Phone #4, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Phone #s, then press Enter.
3. Scroll up/down to Phone #4, then press Enter.
4. The first digit of the current value of this option now flashes (this may take up
both lines on the display). Change each digit of the phone number by scrolling
or entering a numerical value, then move to the next digit by pressing Enter.
5. When done, press Enter again to save the new phone number.