Interlogix Simon XT Tabletop User Manual - Manual (Page 39)

Simon XT TableTop Control Panel User Manual 33
The sections below describe the options that you can program in the System
programming menu.
Access codes
There are three types of access codes: master, user, and duress.
Master code
The master code is your most powerful code and can be used for all user
operations including programming.
To change the master code, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Access codes, then press Enter.
3. Scroll up/down to Master code, then press Enter.
4. The current value of the code now flashes. Enter a new code (use correct
length), then press Enter.
5. Press Status repeatedly to exit.
The initial value of the master code is 123, 1234, 12345, or 123456, depending
on the installer-programmed access code length.
User codes 1 to 8
There are eight user codes, which can be used for many user operations, but not
subdisarming, programming, or bypassing sensors.
To change a user code, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Access codes, then press Enter.
3. Scroll up/down to the user code you want to change, then press Enter.
4. The current value of the code now flashes. Enter a new code (use correct
length), then press Enter.
5. Press STATUS repeatedly to exit.
Initially, all user codes are blank. You can delete a user code by pressing Disarm
while the code is being changed.
Duress code
The duress code, when used in place of another user code, generates a silent
duress alarm which is reported to the central monitoring station.