Interlogix Simon XT Tabletop User Manual - Manual (Page 41)

Simon XT TableTop Control Panel User Manual 35
6. Press Status repeatedly to exit.
You can delete the phone number by pressing the Disarm button while changing
a digit.
Timers
The latchkey time option is the only timer setting available to you. The latchkey
time is the time of day by which the panel must be disarmed to avoid triggering a
latchkey alarm, if the latchkey time option is enabled during arming.
To change the latchkey time, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Timers, then press Enter.
3. Scroll up/down to Latchkey time, then press Enter.
4. The HH (hours) part of the time now flashes. Program the hour value by
scrolling or entering a numerical value, then press Enter.
5. The MM (minutes) part of the time now flashes. Program the minute value by
scrolling or entering a numerical value, then press Enter.
6. If you are using 12-hour clock format, the a or p (AM/PM) part of the time now
flashes. Select a or p by scrolling, then press Enter.
7. Press Status repeatedly to exit.
Siren options
The panel has two built-in sound sources, a piezo siren and a speaker. The piezo
siren makes alarm beeps and status beeps. Fire and intrusion alarm beeps are
always played at high volume, while the volume of status beeps (such as trouble
or chime beeps, entry and exit delay beeps, or auxiliary alarm beeps) is
programmable. The speaker emits the panel's voice and also sounds beeps
when a key is pressed. Its volume is also programmable.
The siren and built-in speaker options consist of the following:
Panel piezo beeps
Panel piezo beeps (status beeps sounded on the siren). This option determines
whether or not the panel sounds nonalarm beeps.
To program piezo beeps, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Siren options, then press Enter.