Interlogix NVR 20 User Manual - Manual (Page 100)

94 TruVision NVR 20 User Manual
Video Loss
All connected IP cameras are by default set to monitor continuously for video
loss. Video loss is the condition where the TVN 20 does not receive data
updates from the IP camera. In addition, all video loss detection events by
default are configured to notify to Interlogix’s TruVision Navigator video software
(Report to Center enabled).
Video Lost, like many other events in the TVN 20, can have a schedule for
monitoring video loss and can have various notifications occur automatically in
response to a video loss event. These notification events include:
 Audio Warning to trigger a local unit audible on the TVN 20 upon an
event (Unchecked by Default).
 Upload to Center should be checked for Interlogix TruVision Navigator
notification (Checked by Default).
 Trigger Alarm Output to fire one or more of the on-the-box alarm outputs
(Unchecked by Default).
 Email Linkage if you want the event to send off an email in response to
an event.
 Trigger Alarm Output to fire one or more of alarm outputs directly on
specific models of supported IP Cameras.
To configure the system responses to these events, please follow the steps
below to configure:
1. Navigate to the Video Lost page from Main Browser Page: Click Config >
under Remote Config area, select Configuration parameters and then
under Channel Parameters select the Video Lost option in the Navigation
window.
2. Select the IP Camera channel to configure video loss settings.
3. To enable video loss detection, click on the Enable Video Lost check box
(Checkbox is enabled by default for all added IP cameras)/