Interlogix NVR 20 User Manual - Manual (Page 66)

60 TruVision NVR 20 User Manual
HDD Group 02 Redundant Drive(s)View
(Cameras D2, D3, D4, D8, D9 are checked for
redundant recording)
HDD Group 01 View
(Make sure that the same cameras (D2, D3,
D4, D8, D9) are also checked for recording)
7. Press Ok which will return you to the previous screen.
8. Press Save to save your settings.
Independent Hard Drive Group Steps
1. Navigate to the HDD Settings page from Main Browser Page: Click Config >
under Remote Config area, select Configuration parameters and then select
the HDD Settings option in the Navigation window.
2. Click on the checkbox for the first hard drive that you want to make an
independent storage group from the main HDD Group 1.
3. Select the HDD Group field and select a new HDD Group number from the
one defined for the normal drive (typically HDD Group 02).
4. Make sure the Attribute field for the selected and from the drop down is set
to Read-Write.
5. Repeat this process (Steps 2-4) for each additional hard drive that you want
to assign to this group.
6. Press the HDD Group attribute button near the bottom of the page
this will open a dialog box where you can define which cameras will be
assigned to this independent recording hard drive group.
7. Select HDD Group 01 from the drop-down and check the cameras required
to be recorded by this group.