Interlogix NVR 20 User Manual - Manual (Page 67)

TruVision NVR 20 User Manual 61
HDD Group 1 View
(Cameras D1-D9 are checked for recording
to HDD Group 1)
HDD Group 2 View
(Cameras D10-D14 are checked for recording
to HDD Group 2)
Select HDD Group 02 from the drop-down and check the cameras to be
recorded in this group.
Note: Whenever you add a camera by default it is included with HDD Group
1.
8. Press Ok which will return you to the previous screen.
9. Press Save to save your settings.
10. Repeat steps 2-10 for each additional Hard Drive Group you wish to create.
Read Only Attribute
By changing the hard drive attribute to Read only, the specified drive can no
longer be written to and the video stored there will remain until the drive is
formatted or the Read-Write attributed is applied.
Formatting Drives
Typically the only reason to format a drive is when you want to erase all video on
the drive or as part of a troubleshooting tip to verify if a drive is faulty.
From the HDD Settings page select the checkbox for each drive that you wish to
format or the Select All checkbox if you wish to reformat all drives. Then press
the Format button. The HDD formatting status area will show the status of the
reformatting process. Once the process is complete a notification window will be
displayed.