Exception parameters – system health monitoring, Stem health monitoring 92 – Interlogix NVR 20 User Manual User Manual
Page 98
92
TruVision NVR 20 User Manual
Exception Parameters – System Health
Monitoring
System capabilities include the detection and notification of various system
health elements designed to protect the proper operation of the unit. These
events can trigger local audible on the TVN 20 unit; they can trigger the local
alarm outputs on the unit and can be sent to video management software such
as Interlogix’s TruVision Navigator software.
The type of events includes:
When these events are configured, the system responses include:
Audio Warning to trigger a local unit audible on the TVN 20 upon an
event (Unchecked by Default).
Upload to Center should be checked for Interlogix TruVision Navigator
notification (Checked by Default).
Trigger Alarm Output to fire one or more of the on-the-box alarm outputs
(Unchecked by Default).
Email Linkage if you want the event to send off an email in response to
an event.
Health Status Item
Description
HDD Full
Reports HDD Full if OVERWRITE is NOT selected for recording. In
this case the drives are set to fill up and stop recording when full.
HDD Fault
Reports if there is a health issue with a specific HDD including
S.M.A.R.T HDD notifications this can include failure of the drive itself.
Network Broken
Connectivity to the network is disrupted.
IP Address Conflict
Reports an error if when adding this TVN 20 in the system if there is
another device using the same IP Address. (Please note: This only
identifies an IP address of the TVN 20 and not any conflicts with IP
camera addresses)
Illegal Access
Under Account Management settings if a User provides the wrong
login credentials or when IP Address Combine or MAC Address
Combine login validation is violated, then this event will be triggered
Record Exception
Reports when a HDD that is expected to be available in the system is
no longer available or the drive is no longer able to be written to.
This could be a case where a drive has been removed or reinstalled
but was not properly recognized by the system.