Juniper Systems Allegro MX User Guide - Manual (Page 27)

3. Tap Power Off. A warning dialog appears. Tap OK.
To power on your Field PC, hold down the Power button until
you see the screen light up.
Note: The Battery Settings screen will appear when you power on
your Field PC .
Suspending the Device
Suspending the Field PC is different from powering it off.
When the device is suspended it goes to sleep, and when it is
turned back on, the device resumes where it was before it was
suspended. Some battery power is used during suspend.
We recommend suspending your device if you plan to turn it
off for less than two weeks as long as the Field PC is attached to
wall charger every night and weekend.
To suspend your device, press the Power button briefly and
release. To resume the device from suspend mode, press the
Power button again.
Resetting the Device
Follow the steps below to reset the Field PC:
1. Save your open files and close any running programs.
2. Press and hold the Power button until the Power Button
menu appears.
3. Choose Reset.
If your device locks up, you can reset the device by pressing
the Power button for 10 seconds or until the screen goes dark.
After a few seconds, the device turns on again.
Ch 4 Using the Hardware
27