Juniper Systems Allegro MX User Guide - Manual (Page 31)

Installing a Micro SD Card
To install a Micro SD card complete the following steps:
1. Use a screwdriver to open the back compartment door.
2. Gently lift the flap located in the top right corner of the
board protector.
3. Slide the Micro SD card door to the right to open it.
4. Slide the Micro SD card into the door with the connectors
facing down and outward.
CAUTION: Do not place the Micro SD card directly into
the board connector. The card reader and the card may be
damaged.
5. Gently shut the door and slide it to the left to lock it.
6. Close the flap in the board protector and securely reattach
the back compartment door.
7. For the card to be recognized, suspend and resume or reset
the Field PC.
Removing a Micro SD Card
To remove a Micro SD card, follow the steps outlined above
starting with step 6 in reverse order.
!!
Ch 4 Using the Hardware
31