Juniper Systems Allegro MX User Guide - Manual (Page 29)

Using the Touchscreen
This section explains how to protect, calibrate, and disable the
touchscreen.
Protecting the Touchscreen
The touchscreen is sealed to protect your device against water
and dust. To protect your touchscreen, we recommend that you
apply a touchscreen protector.
Calibrating the Touchscreen
If the touchscreen is not responding accurately to stylus taps, try
calibrating the touchscreen manually using the following steps:
1. Tap Start > Settings > System tab.
2. Scroll down and tap on the Screen icon.
3. When the Screen window appears, tap Align Screen.
4. Follow the directions to calibrate the touchscreen.
5. After you calibrate the touchscreen, the Screen window
appears again. Tap OK to exit the screen.
Disabling the Touchscreen
To disable or enable the touchscreen, press the BLUE shift key
then the TS key.
Ch 4 Using the Hardware
2