Juniper Systems Allegro MX User Guide - Manual (Page 28)

2
Field PC Owner’s Manual
Restoring the Device to its Factory State
Follow the steps below to restore user storage, settings, and
icons on your Field PC to their original factory defaults.
CAUTION: Restoring the Field PC to its original factory state
permanently erases data saved on the Field PC, any software
you installed, and any changes you made to the Field PC
(including setting changes).
1. Back up data and software you want to reinstall on the
Field PC on removable media or a desktop computer.
2. Press and hold the Power button until the Power Button
menu appears.
3. Choose Reset and quickly press and hold the Ctrl + Alt
+ Del buttons. A progress bar appears. Hold the buttons
down until the second tick on the progress bar is shown.
Data and software stored on removable media (Micro SD or PC
card) is not erased during a clean boot. However, software may
need to be reinstalled on the Field PC after a clean boot.
Using the Stylus
Below are instructions for tasks using the stylus.
To do this . . . Follow these steps
Select an item Tap once.
Open an item or file Tap the item or file twice.
Open a context menu
for an item
Tap and hold the item. The context
menu appears.
Cut or copy Tap and hold until the context menu
appears. Select Cut or Copy.
Paste Tap and hold the area where you
want to paste. Select Paste from the
context menu that appears.
Drag and drop Tap and drag the item to the
destination. Lift up the stylus.
Select multiple items Drag the stylus over the items.
!!