Juniper Systems Allegro MX User Guide - Manual (Page 7)

Getting Started
Install the Battery Pack
When you receive the Field PC, you must install and charge
the NiMH battery pack before using. To do this, complete the
following steps:
1. Push up on the sliding latches on the sides of the Field PC
to open the battery compartment door.
2. Place the NiMH battery pack in the left side of the battery
compartment, push down, and slide it all the way to the
right. There is a small arrow on the bottom right corner of
the battery pack, make sure the arrow is pointing to the
right when it is placed in the Field PC.
Ch 1 Getting Started
7