Conair B32 - Manual (Page 61)

Basic 32 Loader Control UGC007/0702
Fault Messages and Error Codes D-7
0083 MAX I/O CABLES
EXCEEDED The maximum number of expansion
I/O cables allowed was exceeded. Non-User
•
Reconfigure the expansion I/O system so
that it has an allowable number of cables.
•
Cycle power.
0084 MAX I/O POWER
SUPPLIES EXCEEDED The maximum number of expansion
I/O power supplies allowed was
exceeded. Non-User
•
Reconfigure the expansion I/O system so
that it has the correct number of power
supplies.
0085 MAX I/O MODULES
EXCEEDED The maximum number of expansion
I/O modules allowed was exceeded. Non-User
•
Reconfigure the expansion I/O system so
that it has an allowable number of
modules.
•
Cycle power.
xx86 (1) EXPANSION I/O
MODULE BAUD RATE
ERROR An expansion I/O module could not
communicate at the baud rate
specified in the user program I/O
configuration.
Non-User
•
Change the baud rate in the user program
I/O configuration, and
•
Re-compile, reload the program and enter
the Run mode, or
•
Replace the module.
•
Cycle power.
xx87
(1) I/O CONFIGURATION
MISMATCH
•
The expansion I/O configuration
in the user program did not match
the actual configuration, or
•
The expansion I/O configuration
in the user program specified a
module, but one was not found,
or
•
The expansion I/O module
configuration data size for a
module was greater than what
the module is capable of holding.
Non-User
•
Either correct the user program I/O
configuration to match the actual
configuration, or
•
With power off, correct the actual I/O
configuration to match the user program
configuration.
xx88
(1) EXPANSION I/O
MODULE
CONFIGURATION
ERROR The number of input or output image
words configured in the user
program exceeds the image size in
the expansion I/O module.
Non-User
•
Correct the user program I/O configuration
to reduce the number of input or output
words, and
•
Re-compile, reload the program and enter
the Run mode.
xx89
(1)(2) EXPANSION I/O
MODULE ERROR An expansion I/O module generated
an error.
Non-User
•
Refer to the I/O status file.
•
Consult the documentation for your
specific I/O module to determine possible
causes of a module error.
xx8A
(1)(2) EXPANSION I/O
CABLE
CONFIGURATION
MISMATCH ERROR
•
Either an expansion I/O cable is
configured in the user program,
but no cable is present, or
•
an expansion I/O cable is
configured in the user program
and a cable is physically present,
but the types do not match.
Non-User
•
Correct the user program to eliminate a
cable that is not present
•
Re-compile, reload the program and enter
the Run mode, or
•
Add the missing cable.
•
Cycle power.
Error
Code
(Hex) Advisory Message Description Fault
Classification Recommended Action