Conair B32 - Manual (Page 7)

UGC007/0702 Basic 32 Loader Control
I
NTRODUCTION
1-3
We design equipment with the user’s safety in mind. You can
avoid the potential hazards identified on this machine by fol-
lowing the procedures outlined below and elsewhere in the
User Guide.
ATTENTION:
R
EAD THIS SO NO
ONE GETS HURT
WARNING: Improper installation, oper-
ation or servicing may result in equip-
ment damage or personal injury.
This equipment should be installed, adjusted,
and serviced by qualified technical personnel
who are familiar with the construction, operation
and potential hazards of this type of equipment.
All wiring, disconnects and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your region.
Always maintain a safe ground. Do not operate
the equipment at power levels other than what
is specified on the the equipment serial tag and
data plate.
WARNING: Electrical shock hazard
This equipment is powered by electrical voltage
as specified on the machine serial tag and data
plate.
A properly sized conductive ground wire from
the incoming power supply must be connected
to the chassis ground terminal inside the
Input/Output enclosure. Improper grounding can
result in personal injury and erratic machine
operation.
Always disconnect and lock out the incoming
main power source before opening the electrical
enclosure or performing non-standard operating
procedures such as troubleshooting or routine
maintenance. Only qualified personnel should
perform troubleshooting procedures requiring
access to the electrical enclosure while power
is on.