KERN & SOHN DLT 100-3N - Manual (Page 19)

DLT_N-BA-e-1421 19
6.5 Mains connection
Power is supplied to the integrated balance via the external power unit. The stated
voltage value must be the same as the local voltage. Only use original KERN mains
adapters. Using other makes requires consent by KERN.
Power supply to the heating module is provided via the supplied mains cable. Do not
connect the instrument to the power grid unless the information on the instrument
(sticker) matches the local mains voltage.
The instrument must be connected to a standard socket with earth terminal. Do not
eliminate the protective effect by using an extension lead without earth terminal. For
power supplies from power grids without earth terminals call a specialist to establish
equivalent protection according to the relevant installation regulations.
6.6 Commissioning
+
Established connections according to diagram and connect to power
supply. Make sure that the tablet is turned off during the connection.
Turn on drying unit at master switch.
After the turn on check, the drying unit will be in default “tablet“ mode.