Moog Crossbow GNAV540 - Manual (Page 99)

GNAV540 User Manual
7430‐0808‐01 Rev. B Page 99
BITstatus Field Bits Value Configurable
Reserved 5:7 N/A N
Status Byte Fields
masterStatus 8 0: nominal
ore status alerts occurred: hardware; com; software; 1: one or m
sensor
Y
hardwareStatus 9 0: nominal
mable alert (refer to 1: program Programmable Status below)
Y
comStatus 10 0: nominal
mable alert (refer to 1: program Programmable Status Fields below)
Y
softwareStatus 11 0: nominal
mable alert (refer to 1: program Programmable Status Fields below)
Y
sensorStatus 12 0: nominal
alert (refer to Programmable Status 1: programmable Fields below)
Y
GPSStatus 13 0 : GPS data valid
d 1: GPS data not vali
Y
HeadingStatus 14 0: heading verified
1: heading not verified
Y
P/Y code detected 15 0: no P/Y code detect
1: P/Y code detected ed
Y
Programmable Status Fields
The BIT status fields can be configured. The operation modes, AHRS, IU, VG and NAV, affect the default value of the
hardware, com, software and sensor status bits. The default settings are appropriate for most installations.
NOTE: red unless determined necessary; incorrect configurations can adversely The settings should not be configu
affect operations.
nfigured NOTE: Error fields cannot be co .
The default values are listed in Table 78 below.
Table 78 Programmable BIT Status–Default Values per Function
Status Byte Field Default Values
master
(bit 8) Status The masterStatus flag is asserted when an enabled alert sig
For information about configuring this status field, refer to BIT Configuration nal is asserted.
on page 56 and
Configuring masterStatus on page 106.