Chaparral Fibre Channel -to-SCSI Router Chaparral FS 1310 - Manual (Page 31)

Configuring the Router
3-3
Accessing the Router Administrator Using the
Ethernet Port
You can access the Router Administrator software using the Ethernet port using Telnet.
For Windows users, if you want to use Telnet, you must configure the preferences and font
from the Terminal menu each time as shown below.
Windows users may want to obtain HyperTerminal Private Edition from Hilgraeve, which
supports Telnet protocol and serial port protocol.
You can configure a variety of settings for the Ethernet connection. For more information,
see
Configuring the Additional LAN Settings on page B-3 .
Using the Ethernet Port for the First Time
Before you can access the Router Administrator software, you must set the IP address and
subnet mask for the controller. The default IP address is 204.132.192.216. You can do this
one of four ways:
!
Setting up your computer with an IP address that is compatible with the controller
default of 204.132.192.216, such as 204.132.192.218.
!
Using address resolution protocol (ARP) to set the address. See Using Address
Resolution Protocol on page B-2 .
!
Using Dynamic Host Configuration Protocol (DHCP) to set the address. See Dynamic
Host Configuration Protocol Configuration on page B-3 .
Once you set the IP address and subnet mask, you can use the steps in the next section to
access the Router Administrator software.
Click Font to set
the font as shown
here.