Chaparral Fibre Channel -to-SCSI Router Chaparral FS 1310 - Manual (Page 93)

Index
I-5
SCSI channels
changing mapping mode 3-20
connecting to 2-7
HVD 2-8
LVD 2-8
problems with 4-5
single-ended narrow 2-8
Ultra2 wide 2-8
SCSI devices
changing addresses of 3-21
changing FC LUNs of 3-21
displaying 3-23
SCSI ID, changing for router 3-12
self-test, table of failures and solutions 4-2
serial port 2-9
connecting to 2-9
problems with 4-4
serverless backup 1-3
Set Date screen 3-14
Set Date/Time screen 3-14
Set Time screen 3-15
setting up the router 3-1
settings
for the RS-232 port 2-9
settings for 2-9 , 3-10
shutting down the router 3-19
SNMP Configuration screen B-7
SOFT setting 3-8 , 3-10
software
accessing to configure the router 3-1
navigating in 3-5
specifications 1-4
ST light 2-11
status lights 2-11
support 4-1
System Configuration screen B-5
System Menu 3-2 , 3-5
T
table, installing the router on 2-2
TCP/IP
configuring the router B-1
setting up to access controller software 3-3 , B-1
using ARP to set up B-2
using DHCP to set up B-3
TCP/IP Configuration screen B-6
technical support 4-1
temperature, alarm thresholds for 3-18
terminal
screen problems 4-5
terminal emulator software 3-1
terminal emulator, problems with 4-4
terminal screen problems 4-4
termination
disabling 3-13
Termination screen 3-13
time, changing for router 3-14
topology
LOOP setting 3-7
POINT-TO-POINT setting 3-7
selecting 3-7
troubleshooting
COM port 4-4
device SCSI channel problems 4-5
problems during bootup 4-1
router not responding 4-6
terminal emulator 4-4
typographic conventions 1-2
U
unpacking the router 2-1
upgrading firmware 3-31
Utilities Menu 3-28 , 4-8
V
voltage, alarm thresholds for 3-18