Chaparral Fibre Channel -to-SCSI Router Chaparral FS 1310 - Manual (Page 91)

Index
I-3
resolving using ARP B-2
resolving using DHCP B-3
L
LAN, setting up to access controller software 3-3 , B-1
LED lights 2-11
LED status lights 2-11
lights 2-11
Loop ID
changing for router 3-8
settings for 3-8
SOFT setting 3-8
Loop ID screen 3-9
Loop ID to AL_PA mapping A-3
LOOP topology setting 3-7
LUNs
changing for devices 3-21
changing for router 3-10
displaying for router 3-30
NONE setting 3-10
settings for 3-10
SOFT setting 3-10
LVD model 2-8
M
MAC hardware address B-2
map
displaying FC-to-SCSI address map 3-23
FC-to-SCSI addresses A-1
Loop ID to AL_PA A-3
mapping mode
AUTO setting 3-20
changing 3-20
FIXED setting 3-20
Mapping Mode screen 3-21
N
navigating in the Router Administrator software 3-5
network
setting up to access controller software 3-3 , B-1
Network Management System Console
SNMP Configuration screen B-7
System Configuration screen B-5
TCP/IP Configuration screen B-6
Network Management System Console screen B-7 , B-8
NONE setting 3-10
P
packing list 2-1
POINT-TO-POINT topology setting 3-7
POST, table of failures and solutions 4-2
powering down
devices 2-10
the router 2-10
powering up
devices 2-10
the router 2-10
Problem 4-5
problems
during bootup 4-1
router not responding 4-6
with COM port 4-4
with device SCSI channel 4-5
with terminal emulator 4-4
with terminal screen 4-4 , 4-5
R
rack, installing the router in 2-3
rebooting
problems during 4-1
the router 3-19
replacing the fuse 4-6
resolving
IP addresses using ARP B-2
IP addresses using DHCP 3-3 , B-3
restarting the router 3-19
Restore Defaults screen 3-19
restoring router configurations 4-3
restoring the default settings 3-18
router
benefits 1-2
changing the date 3-14
changing the initiator ID 3-12
changing the Loop ID 3-8
changing the LUN 3-10
changing the scan delay 3-15
changing the SCSI ID 3-12
changing the time 3-14
configurations restoring 4-3