Chaparral Fibre Channel -to-SCSI Router Chaparral FS 1310 - Manual (Page 79)

LAN Configuration
B-5
System Configuration Screen
Option 1 from the Network Management System Console screen displays the System
Configuration screen.
Table B-1 describes the settings you can change here.
Table B-1. System Configuration screen settings
Option Setting Description
1 System name Name of the router as seen by other systems on the network.
You can enter up to 80 characters. Default is router fxxxxx
where xxxxx is the last 5 digits of the MAC address.
2 System Contact Name of a contact person responsible for the router. You can
enter up to 80 characters.
3 System
Location Location of the router. You can enter up to 32 characters.
4 Telnet Password Password for accessing the router using the Ethernet port and
Telnet. You can enter up to 32 characters. Default is null (press
Enter).
5 Telnet Timeout Number of idle seconds before the Telnet session times out.
Default is no timeout.
6 FTP Login
Name Login name for FTP access to the router. You can use FTP to
download firmware updates. You can enter up to 15 characters.
Default is flash.
7 FTP Password Password for FTP access to the router. You can enter up to 15
characters. Default is flash.
8 Allow FTP
Updates? Yes or No toggle. This permits firmware updates to the LAN
board using FTP.
9 Jump to
Controller? Yes or No toggle. Yes means the Router Administrator software
displays after connecting to the controller using the Ethernet
port. No means the Network Management System Console
screen displays after connecting to the router using the Ethernet
port. The default is Yes.
ESC Exit Saves all changes and returns to the Network Management
System Console screen