Chaparral Fibre Channel -to-SCSI Router Chaparral FS 1310 - Manual (Page 32)

FS1310 Rack/Desktop Model User’s Guide
3-4
Accessing the Router Software Using the Ethernet Port
You can configure a variety of settings for the Ethernet connection. For more information,
see
Configuring the Additional LAN Settings on page B-3 .
To access the Router Administrator software using the Ethernet port and the Telnet
utility:
1 Set up the IP address and subnet mask as described in Using the Ethernet Port for the
First Time on page 3-3 .
2 At the DOS or UNIX prompt, enter telnet and press Enter.
3 Using the Terminal menu, select Preferences.
4 Select VT100 Arrows option, VT-100/ANSI emulation, and terminal font. Select
OK.
5 Enter the IP address or, using the Connect menu, select the controller IP address from
the menu (if present) and press Enter.
6 Enter the port number.
The port number is default port 23.
The Enter Password screen displays.
7 Enter your password and press Enter.
There is no default password, just press Enter.
The initial Chaparral Router Administrator screen displays. If an alarm condition has
occurred, you will see a message about the problem. This message will also be stored
in the event log.
Note: If a Telnet session is active, you cannot make changes to the
configuration using the RS-232 connection.