Cingular X-C 6250 Pro (300) - Manual (Page 115)

115
Appendix A. Error Messages
79-0030-001 11 January 2001
Non-system disk or disk error — Replace and press any key to
continue
Remove the non-bootable PC memory card from the card socket and
press any key to reboot.
Non-system disk - insert boot disk and press any key
Restart the computer by pressing both mouse buttons for at least 10
seconds and then releasing the buttons. If the problem persists, contact
your organization’s help desk.
Press the F1 key to continue
This message indicates that an error was found during POST. Pressing
the F1 key allows the system to attempt to boot.
Shutdown failure
Reboot the computer by pressing CTRL+ALT+DEL . If the message
persists, contact your supervisor or your organization’s help desk.
Unexpected interrupt in protected mode
Reboot the computer by pressing CTRL+ALT+DEL . If the message
persists, contact your supervisor or your organization’s help desk.
WARNING! PC87570 initialization incomplete. Code=XXX
Press ENTER to continue and then restart the computer by pressing
CTRL+ALT+DEL . You can continue to use the computer since basic
computer functions may still be operable; however, some functions may
not work properly.
If the problem persists, contact your supervisor or your organization’s
help desk.
WARNING! Boot sector 0 has changed
The boot sector of the hard drive has been modified. This message also
may be displayed when booting from drive C after booting from another
device. Pressing F1 will allow the system to continue to boot. If this
problem persists, contact your organization’s help desk.