Cingular X-C 6250 Pro (300) - Manual (Page 45)

45
Section 4. If You Have a Radio Modem
79-0030-001 11 January 2001
GSM
To use your GSM International Radio Software you will need to install
the GSM modem, the GSM software and a 3V Subscriber Identity
Module (SIM) Card.
To install the Wavecom GSM modem, do the following:
1 Go to Start, Settings, Control Panel and click on Modems.
2 Click Add.
3 Check the box “Don’t detect my modem, I will select it from a list”,
then click Next.
4 Select the “Manufacturers” Wavecom name, and the “Models”
Wismo2C, then click Next.
5 Select to install your modem as “Selected ports” on COM4 and click
Next.
6 Select Finish, then Close.
7 You may have a window titled “Modem Setup” that pops up and
says:
“Dial Up Networking needs to be configured because the list of
installed modems has changed. Would you like to do this now?”
Select Yes.
8 You will have a window pop up that is titled “Remote Access Setup”.
Select Add. A window will pop up titled “Add RAS Device” with
“COM4 - Wismo2C”. Select OK.
9 Select Yes when it asks you to restart your computer.
CAUTION Your modem generates radio frequency (RF) signals. Do
not operate the radio modem before you have registered it with a
network provider. The network will not accept a signal from an
unregistered device. Unauthorized use of your radio modem may
interfere with local business or government communications,
resulting in fines or other legal action.