Cingular X-C 6250 Pro (300) - Manual (Page 77)

77
Section 7. Using PC Cards
79-0030-001 11 January 2001
2 Position the card and carefully slide it into the card socket until it is
firmly seated.
3 Close the PC card door and push the latch up to secure it.
To remove a PC card
1 Before you remove the card, right click on the card wizard icon in
the system “tray” area of the screen (near the clock in the lower right
corner), and choose “Stop [card name] card.” If the card is not
highlighted the system must be shut down to remove the card.
2 Provide a suitable environment for the computer, and then open the
PC card door by pushing in on the door and sliding the latch down.
3 Press the ejector button.
4 Carefully slide the card out of the socket.
Important Make sure the card is positioned correctly when you
insert it. Attempting to insert the card upside down can damage
the ejector button, and this may cause the button to malfunction
when you remove the card.
Tip Use one finger to press down lightly on top of the card, and
then slide it out. If the ejector button malfunctions when you press
it, release the button and press it again.
Warning Some PC cards are not “hot swappable,” removable
while the system is operating. Removing these while the system is
operating will shut down the unit.