PRG Bad Boy User Manual 1.6 - Manual (Page 26)

18 BAD BOY ® SPOT LUMINAIRE USER MANUAL
Figure 2-3: Hanging Bracket Orientations
Standard Hang
WARNING: The luminaire is heavy. Use caution when lifting.
WARNING: Two safety cables and at least two truss hooks should be used in all hang configurations.
To install in standard 2-point hang:
Step 1. Unpack case and attach Hanging Brackets.
Refer to "Unpacking and Attaching Hanging
Brackets" on page 17.
Step 2. Roll case to mounting location as required
(Figure 2-4).
Step 3. Using two people, carefully lift luminaire into
mounting position.
Step 4. Secure in place by tightening Truss Hook wing
bolts (Figure 2-5). Ensure that luminaire is fully
supported.
Step 5. Feed safety cables through mounting bracket
slots and secure around pipe as shown in
Figure 2-5.
3-Point Hang * 2-Point Hang
* Requires three brackets.
Truss Pipe
Figure 2-4: Removing Luminaire From Case