PRG Bad Boy User Manual 1.6 - Manual (Page 67)

BAD BOY ® SPOT LUMINAIRE USER MANUAL 59
SOFTWARE UPDATE
Software Update Using LumLoader Application
Introduction
The LumLoader application allows you to update the software in a Bad Boy Luminaire. The update will be sent over an
Ethernet connection. The luminaire can take the Ethernet input directly, or the update can be translated to DMX512
signal with an appropriate device, either Series 400® or a Virtuoso® Node (with the required software update). The
fixtures can be daisy-chained to load multiple fixtures at once.
Supported configurations:
Note: There should be no active control (DMX512 or Art-Net) during the update process.
Preparation - Java
The loader (LumLoader) is a Java application which can be run on a Mac or a PC computer.
Note: For Microsoft Windows® users: Windows does not come with the required Java run-time library installed, so
you may need to go to the Sun website (java.com/getjava/) to download Java.
Selecting an Ethernet Interface
Connect the computer to the system, and start the LumLoader application. When the application starts, it will ask
which active Ethernet port should be used. Select the appropriate port. You may be able to differentiate the ports by
IP address, compared with your network setup. Typically the en0 is the first built-in Ethernet port, and other interfaces
could include additional network ports or wireless adapters.
Selecting the Module
The loader can support multiple versions of software, so make sure the appropriate version is selected. The default
version will typically be fine.
Download the Software
Press "Start Download" to initiate the update. You should see the luminaires immediately drop into the startup screen
and erase flash, which takes about 30 seconds. Then the new module is sent out, the screen indicates "Loading",
and when complete they will go back to the main menu and start calibration.
If the fixture already has the update software version, it will not complete the update.
Note: There is a bug in some versions of the boot software that causes the screen to go white during the update
process. Let the download complete before resetting the fixture, it will usually work fine.
Mac/PC Ethernet Bad Boy Ethernet Bad Boy ...
Mac/PC Ethernet Series 400 Ethernet Bad Boy Ethernet Bad Boy ...
Mac/PC Ethernet Series 400 DMX Bad Boy DMX Bad Boy ...
Mac/PC Ethernet Virtuoso Node DMX Bad Boy DMX Bad Boy ...