PRG Bad Boy User Manual 1.6 - Manual (Page 36)

28 BAD BOY ® SPOT LUMINAIRE USER MANUAL
Ethernet (Art-Net) Comm
The starting address for Ethernet (Art-Net) systems is programmed using the CONFIG menu.
To program a starting address:
Step 1. At Home screen, press CONFIG panel.
Step 2. At Configuration screen, press DMX ADDRESS panel.
Step 3. At numeric keypad, enter new starting address and press ENTER.
Figure 2-14: Setting Starting Address (Ethernet Control)
To select an Art-Net universe:
If using Ethernet control, a universe must be selected in addition to the DMX address. The universe can be selected
and displayed in either alphabetic or numeric mode (using the UNIV FORMAT screen). The alpha mode is useful to
differentiate universes from DMX addresses and is the standard on Virtuoso® control systems. In alpha mode, the
valid universes are A-JE, selected from the alphabetic keypad (as shown below). If in numeric mode, the valid
universes are 0-255, selected from the numeric keypad.
Figure 2-15: Selecting a Universe (Ethernet Control)
Note: Refer to "Menu System" on page 34 for more information about the Menu Touchscreen.
Control Input Type