PRG Bad Boy User Manual 1.6 - Manual (Page 30)

22 BAD BOY ® SPOT LUMINAIRE USER MANUAL
Standing Position
The Bad Boy Spot Luminaire can also be used in a standing position. Be sure that the floor or stage will
accommodate the load of this moving luminaire.
To install in a standing position:
Step 1. Unlatch and remove case lid (Figure 2-8).
Step 2. Remove Power Cord and Safety Cables from case.
Step 3. Tilt case upright as shown. Use grips on bottom of case to assist in tilting upward.
Step 4. Carefully remove luminaire from case and place in standing position.
Step 5. Connect power and data cables according to "Connecting Power and Data" on page 23.
Figure 2-8: Standing Position
Power Cord and
Case
Safety Cables
Case
1
2
3 4
Grips