SmarTek Systems SVS-1 User Guide-Part B - Manual (Page 16)

Scenario 2 Set Output Relays
Select Detector Interface and Route Relays:
1) Click the Detector Interface button to select
the type of detector/controller interface to be
used ( Type-170 ).
2) Click the Ph- button to select Phase group
1L. Note that the line zones corresponding to
the selected phase group turn green. All others
are magenta.
3) Click the RI/Card= button to select the
number of relays per card = 2 .
4) After selecting the RI/Card=4, the number
card edge relays (F,W,etc.) that are shown
changes corresponding to this selection.
5) Click the Ext= and the Dly= to select the
Detection Extension in seconds and the
Detection Delay in seconds.
6) Click N, Or, And button to select logic for
combining (N=Not Used) Phase Groups into
Card Edge Relays.
7) To clear the settings for the selected Phase
group or for all Phase groups click the Clear or
the Clear All button.
1
3 2
4
7
5
Type-170 Detector/Controller Interface with 2 Relays per SVS-1 card and 3 Phases (Line Zone Groups)
Phase 1L, Detection Delay=0 sec, Detection Extension=0, Route to Card Edge F
Phase 6T, Detection Delay=0 sec, Detection Extension=0, Route to Card Edge W
Phase 6R, Detection Delay=2 sec, Detection Extension=0, Route to Card Edge W
6
Specifies Routing to Onboard Output Relay
Connector (1, 2, .., 10 0-Disables) for shelf
mount SVS-1