SmarTek Systems SVS-1 User Guide-Part B - Manual (Page 5)

Setting up the SVS-1 using SVS Setup and Monitor Version 3 (PC Required)
After clicking the SVS/Get Image for Zone Setup menu item to open the Zone Setup window, the following steps outline the setup
procedure:
Important Note: The setup procedure uses familiar mouse “point and click” techniques. For most
displays and buttons, clicking in the upper/lower portion of the button field will
increment/decrement the selected detection zone, the parameter to be changed, the phase to be
assigned, or the parameter value being set.
1) The Main Setup display has several options. For initial SVS-1 setup, first click the Draw LZs button to proceed to the Draw
Line Zones display to draw each detection line zone (create multiple line zones for each lane) and then assign or group line zones
to an intersection phase. After all desired detection line zones have been drawn and grouped in phases, set line zone parameters
by clicking the Default Parameters-All LZs button. Typically, predetermined (default) parameters are used for most
applications. After setting parameters, return to the Main Setup display.
2) From the Main Setup display, proceed to the Set Output display by clicking the Set Output button to specify the detector
interface type , combine phases into vehicle presence relays, and then route them to output detector channels. After setting the
output relay signals, return to the Main Setup display.
3) From the Main Setup display, proceed to the Set Video Out Text display by clicking the Set Text Display button to specify
the video monitor text and to specify it’s position in the output video image. After setting the output video text, return to the Main
Setup display.
4) After the SVS-1 setup is complete, click the OK button to exit Setup and return to the SVS main display.
5) Settings must now be sent to the corresponding SVS-1 camera processing channel (SVS0001, SVS0002, etc.) to remove the
yellow parameter mismatch warning flag. This is done by clicking the SVS/Send SVS Parameters menu item on the main SVS
display.