SmarTek Systems SVS-1 User Guide-Part B - Manual (Page 32)

Next, click the OK button on the Detection Zone Setup window to capture the settings and close the window.
Closing Setup Windows and Saving Setup Parameters
Note that settings must be sent to the
corresponding SVS-1 camera processing
channel (SVS0001, SVS0002, etc.) to
remove the yellow parameter mismatch
warning flag.
In addition to the Set Output display previously described, the Detection Line Zone Mapping display may also be used to combine
Detection Line Zones and assign them to Phases and then route the Phases to output detector channels. If the Set Output display is
used as the primary means to setup the SVS output, then the Detection Line Zone Mapping display may serve as a summary display
to review the settings. To open this display from the Set Zones display click the Output Relays/Set Output Relays menu item.