SmarTek Systems SVS-1 User Guide-Part B - Manual (Page 8)

Draw Line Zones
Phase assignment Codes:
Ph-1L
Ph-6T
Ph-6R
Ph-3L
Ph-8T
Ph-8R
Ph-5L
Ph-2T
Ph-2R
Ph-7L
Ph-4T
Ph-4R
Ph-9L
Ph-14T
Ph-14R
Ph-11L
Ph-16T
Ph-16R
Ph-13L
Ph-10T
Ph-10R
Ph-15L
Ph-12T
Ph-12R
After drawing all line zones and grouping
by phase, click the Main Setup button to
return to the Main Setup Display.
SVS-1 detection is directional, hence, be
sure the direction arrow on each line zone is
pointed in the correct direction of travel.
L designates Left Turn Lane
T designates Thru Lane
R designates Right Turn Lane
Note: The “T” and “R” designation allows for later
applying detection delay and/or extension to the right
turn and/or thru lanes before combining them into one relay.
The selected line zone is shown in green,
all others are shown in red (show in output
video) or gray (not show in output video).
Clicking in the upper/lower part of the
button field will increment/decrement
the value or the selection.
Phase 1L Phase 6R Phase 6T