SmarTek Systems SVS-1 User Guide-Part B - Manual (Page 39)

Next, click the OK button on the
Detection Zone Setup window to capture
the settings and close the window.
Closing Setup Windows and Saving Setup Parameters
Note that these settings must be sent to the
corresponding SVS-1 camera processing
channel (SVS0001, SVS0002, etc.) to remove
the yellow parameter mismatch warning flag.
After assigning/reviewing Detection Line
Zones to Phases and then routing them to a
Detector Channel, click the OK button on
the Detector Line Zone Mapping window
to capture the settings and close the
window.