SmarTek Systems SVS-1 User Guide-Part B - Manual (Page 37)

Routing Each Phase to SVS Relay Interface Card Edges for a Type 170 Card file
1) Click the Clear All Detector Routing Check Boxes button to clear all of the right side routing check
boxes. Click the Detector Interface field to select T-170-CardFile.
2) Click in the Relays per SVS-RI Card field to select the number of Relays per card.
3) Note that choosing the Detector Interface as Type 170 reveals the card edge signals (F, W, S, Y) available
for use.
Refer to SVS User Guide Part C for Type 170 card file signal routing.
4) Click each routing check box (right side check boxes) to specify which Phases will be combined (Or’ed
or And’ed) and routed to each card edge. For this example, Phase-1L is routed to edge F and Phase-6T and
Phase-6R are routed to W on the Main SVS-RL card. The AUX SVS-RL card is not used.
1
1 2
3
4