SmarTek Systems SVS-1 User Guide-Part B - Manual (Page 33)

Assigning Line Zones to a Phase and Routing to the Output Detector Channels
Detection Line Zone Number
This display may also be used to combine Detection Line Zones (columns) and assign them to a Phase (rows) on the left half of the display.
The right half of the display is then used to combine Phases (via ANDing or ORing) and route them (rows) to Detection Channels
(columns- D01, D02, etc.). If the Set Output display is used as the primary means to setup the SVS output, then this display may serve as a
summary display to review the settings. To open this display from the Set Zones display click the Output Relays/Set Output Relays
menu item.
Parameters across the bottom of the window specify the location and display of Site Text in the output
video signal . The video image upper left position is (0,0) while the lower right is (719,479).
Current Camera Channel ID
Phase Label
Output Interface Type Selection
Use to Clear All Check Boxes for Phases and/or
Detector Channel Routing Output Detector Channel
or RL Card Edge